Classic V-Belts (A, B, C, D, E) (1/2") A Classic V-Belts (21/32") B Classic V-Belts (7/8") C Classic V-Belts (1-1/4") D Classic V-Belts (1-1/2") E Classic V-Belts; Classic Banded V-Belts (A, B, C,

Belt Size Conversion Chart ; 32", 81 cm ; 34", 86 cm ; 36", 91 cm ; 38", 97 cm.

A - The A stands for an "A" section v-belt. This is considered a "Classic" v-belt style that has a top width of ½ (0.5) inches and a thickness of 5/16 (0.312) inches. 41 - 41 inches is the inside circumference of the belt. For A-section v-belts, the outside circumference is found by adding 2 inches to the inside length of the belt.

Figure 2: Diameters of a two-pulley system For example, consider calculating the length of a V-belt in a factory. The diameters of the pulleys are given as 20cm, and 12 cm, respectively, and

The inside length of the belt is typically 2" less for a 4L belt, and 1-1/2" less for a 3L belt. An example would be 4L460, which would be 46" long outside, 44" inside. "Classic" v-belt numbers start with a letter identifying the cross section, “A” through “E” - see V-Belt Dimensions below. “A” series belts are the most common.

See belt cross reference for 4L to A and 5L to B sizes. A & AX Size v-belts Nominal length = Inside length / Outside Circumference = Inside length + 2" D Size v-belts 225 & up Nominal Length = Inside length + 2.5" / Outside Circumfernce = Nominal length + 2.5" 3L, 3V, 4L, 5L, 5V, 5VX & 8V Size v-belts Nominal length = Outside Circumference

Drive Belts for Hytrol 138/190-ACC. Use the chart below to guide you when selecting which v-belt to purchase and where to install each one. V-belts are considered a critical part, will cause downtime if it breaks, and should be kept on site in the various lengths required for your facility. Measure the bed section by measuring the distance

The numerical prefix indicates the belt top width in one-eighth of an inch, followed by the nominal outside length in inches. For example, 3L300 part number indicates 3/8" top width with 30.0" outside length. V-Belt Size Chart V-Belts come in many sizes and lengths. V-belt cross-sections can be identified by their top width and depth dimensions.

21/3/2022 · Belt Size Conversion Chart Americans prefer to use inches in belt measurements, while European countries favorise in centimeters. Still, many brands use a more standard

Convert the waist size measurement into the desired international Belt Size. The waist size is not the same as the belt size. When measuring in inches, go 2 inches up as a rule of thumb. Over time, leather belts tend to stretch. Braided belts or belts made out of synthetic or Vegan leathers even more so.

For Optibelt V-Belts, you can easily find the correct type of V-Belt by calculating its datum length (Ld) as shown in the Conversion Table